There are no products listed under this category.
The Mounting & Wiring category brings together the brackets, hardware, wiring harnesses and cable-management accessories that keep condensate pumps, float switches and sensors installed securely and wired correctly. A reliable condensate system is more than just the pump: how you mount it, support it and route low-voltage wiring determines long-term performance, noise level and serviceability. This section is built for techs who want clean, professional-looking installs that are easy to troubleshoot on the next visit.
You’ll find pump mounting brackets, wall and pan brackets, vibration-isolation pads, mini-split mounting plates, pre-terminated wiring harnesses, low-voltage wire, spade and quick-connect terminals, junction blocks and cable ties. Many accessories are sized specifically for condensate pumps, pan switches, float switches and mini-split safety sensors, allowing you to mount components solidly without improvising with scrap materials. Color-coded harnesses and labeled conductors simplify wiring into R, C, Y, W or dedicated alarm circuits.
When choosing mounting and wiring accessories, verify pump or switch footprint, mounting surface (deck, wall, pan, strut), vibration levels, wire gauge requirements and control circuit voltage. Mount condensate pumps on solid, level bases with isolation pads where noise is a concern. Route low-voltage wiring away from standing water and sharp edges, and use cable management to keep drain pans and access areas clear for future service.
Pro tip: Treat every condensate install like a long-term service account. Use dedicated brackets, labeled wiring and tidy cable routing so any tech can understand the system at a glance. Document which float, pump or sensor is tied to each safety circuit on the air handler door or service label.
Mounting and wiring accessories for HVAC condensate systems include pump brackets, pan and wall brackets, vibration-isolation pads, pre-wired harnesses, low-voltage wire, terminal blocks, connectors, clamps and cable ties. These components ensure secure installation, quiet operation and clean wiring for pumps, float switches and safety sensors.
There are no products listed under this category.