There are no products listed under this category.
The Nuts, Washers & Threaded Rods category covers the core fastening hardware behind your hanger systems, strut frames and equipment supports. Every duct run, air handler rack, mini-split bracket and trapeze hanger depends on the right combination of rod, nuts and washers to carry the load and stay secure over time—especially in high-vibration mechanical spaces and rooftop environments.
Here you’ll find threaded rod in common HVAC sizes (1/4", 3/8", 1/2", 5/8"), hex nuts, locking nuts, strut-channel nuts, flat washers, fender washers, lock washers and structural washers. Options are available in zinc-plated, hot-dip galvanized and stainless-steel finishes so you can match the hardware to the environment—indoor mechanical rooms, rooftop curbs, coastal installs or high-humidity spaces.
When selecting nuts, washers and threaded rods, verify the rod diameter, thread pitch, material/coating, load requirements and installation environment. Long trapeze runs and equipment racks may require heavier diameters or additional bracing, while coastal and rooftop locations generally demand hot-dip galvanized or stainless hardware for long-term corrosion resistance.
Pro tip: When cutting threaded rod in the field, always run a nut onto the rod before cutting. After the cut, backing the nut off will clean the threads and make it easier to start additional nuts in tight overhead spaces.
HVAC nuts, washers and threaded rods including hex nuts, lock nuts, flat and fender washers, lock washers, strut-channel nuts and zinc, galvanized or stainless threaded rod for hangers, trapeze supports and equipment frames.
There are no products listed under this category.