The Roof & Wall Supports category focuses on the transition points where piping, conduit, ductwork and equipment move across rooflines and walls. These supports keep mechanical runs secure, off finished surfaces and properly aligned as they travel up exterior walls, over parapets, across roof edges and into mechanical spaces, helping protect both the building envelope and the HVAC system.
Here you’ll find roof-edge support brackets, wall standoff brackets, pipe guides, corner and offset supports, parapet brackets, combination roof/wall support kits and adjustable rail systems. These components are used with refrigerant line sets, hydronic piping, electrical conduit, drain lines, small duct sections and cable trays in residential, commercial and light-industrial projects.
When selecting roof and wall supports, check pipe and conduit size, total load, wall construction, roof type, required clearances, thermal expansion, wind exposure and corrosion resistance. Proper supports help prevent rubbing, sagging and damage at transition points, reduce noise and movement in high-wind events, and protect membranes, cladding and sealants from long-term wear.
Pro tip: Lay out full roof-to-wall routing before mounting the first bracket. Align supports with penetrations, bends and equipment connections so line sets and piping run straight, with room for insulation, expansion loops and future service.
Roof and wall supports including roof-edge brackets, parapet supports, wall standoffs, corner and offset supports, adjustable rails and combination roof/wall kits for routing refrigerant lines, hydronic piping, electrical conduit and drain lines across roofs and exterior walls.
